4 Axis Optical Encoder USB Readout Unit

This is a very cost effective system for 4 Axis Reading trough USB Port.You can use this system to direct control of 4 Axis of any CNC. By this system you can easy generate the required signals to drive 4 DC motors and get current feedback from them trough internal ATD with 10 bit resolution. You wont need to write any code to read and write trough USB port because everything is done by our software team. Just use our standard OCX program under Labview or VB. For E-mail assistance please Click Here.

 Click on Picture to View Demo

 Features

• 4 Axis Simultaneous Read out via USB.

• No Power Supply is required.

• 1X, 2X , 4X Hardware resolution Multiplier for encoder logics.

• Programmable Divisions setup For Different kind of Encoders.

• Programmable Index to work in continuous counter mode or absolute angle measurement.

• High speed transfer rate trough USB 1.1(12 Mb/s) fully compatible with USB2.0.

• No knowledge of USB port is required.

• Work easily in VB via standard Xilag OCX Program.

•  Work easily in Labview Trough Xilag .vi program.

• 4 channel Programmable PWM output.

• 4 channel Analog input 10 bit resolution.

• 16 channel digital input.

• 16 channel digital output.

• Miniature size.

• Best solution for small size CAD/CAM machines.

• Programmable I/O for your special applications upon request.

• Three independent PID controller with programmable sample time and floating point calculation.

• Flash able Coefficient for All PID's, Encoders ,Gains, etc which makes system works independent of computer.

• Programmable Hardware with FPGA technology which makes board compatible with new Requirements.

• Easy setup for any 4 Axis Robot or CNC machine.

• No limitation in number of the boards. A pair of this board can control 6 Axis simultaneously.

• Lots of I/O which can be changed by customer request.

• 40MHZ Operation frequency which can easy raise up to 80MHz only by changing the oscillator.

• The best solution for Control Lab Applications with minimum cost.

• Can be easy used as DAQ application in Labview.

• Noise filtered system by using different ional Op Amps. 

• Easy setup for Adaptive control method. upon request.

• Easy programming via Xilag Interface .

• No initial programming is needed for first installation.

• Programmable Hardware which makes board compatible with any application.

• Can be easy used for Optical Rotary Encoders or Linear Encoders.

• Hardware reverse counter overflow protection.

• Ability to count the number of revolutions in the long C format.